The device includes photocell actuated positioning controls to automatically position the load over the Turntable. This unit is a modular self-contained device, which is an integral part of a Power Live Roller (PLR) Conveyor, allowing it to be easily installed into a new or existing plant layout. The turntable device is available in two designs:
Ring & Cross Arm Design: Device has a Rotating Ring and Cross-Arm assembly which is mounted on an air actuated lift to provide 90-degree rotation of loads without changing direction of flow. This device is typically utilized in a strapper area and requires loads to be centered across the width of the conveyor to operate properly.
Device Length: 10′ long minimum. Device can feature a cantilever with Chain-Assist Rollers to insure complete conveyance of product through a 1-Head Strapping operation (if applicable) without any “dead rollers” beneath the strapper.
Conveyor Drives: Dual belt conveyor drives with speeds ranging from 30 to 80 fpm.
Turntable Drive: Rotates the Turntable Ring in continuous 90-degree increments. Variable Frequency Drive is provided for controlled acceleration and deceleration.
Turntable Ring: 65” outside diameter constructed of 2” x 2” Structural Angle which is supported at all times at six (6) 2” flanged Roller Supports.
Sideframe: 5” x 6.7# Structural Channel with 1/4” x 2-1/2” “Drop-In” Roller Support Bar. All rollers are 2-1/2” diameter with 5/8″ or 11/16” hex shafts with sealed grease packed and shielded bearing. Unit can feature Knurled Rollers to aid in the conveyance of pallets (if applicable).
Preassembly: Unit is wired and (if applicable) plumbed to a junction box at the factory. OEM units can be prewired to the control panel.
Conveyor Height: 12” TOR minimum with Leg and Device Extensions available for other heights.
Capacity: 5,000 lbs. maximum.